EpoCAT FR1000

The board is compatible with EtherCAT protocol. With a maximum output frequency up to 1MHz, it is ideal for applications with step motors, and applications with burst piloted brushless motors. The board manages up to 5 axes in frequency, 4 inputs, 2 outputs, 1 DAC of 12 bit and 2 ADC of 12 bit. The board is supplied with all connectors and can be installed on DIN guide. Since it is a compatible slave EtherCAT board, it is possible to use it with any EtherCAT Master board of AxesBrain or LinuxCNC type or other.

Characteristics

  • 5-CH 5Volt for frequency signals pulse
  • 5-CH 5Volt for direction signals
    The frequency and direction signals can be in:
    1 differential mode (1MHz)
    2 single ended positive mode (250KHz)
    3 single ended negative mode (250KHz)
  • 5-CH 5Volt for enable/boost signals
  • 5-CH DI 24Volt for motor drives OK
  • 1-CH DI 24Volt for inverter drive OK
  • 5-CH DI 24Volt for home microswitch
  • 4-CH DI 24Volt for general purpose
  • 5-CH DI fast input for motor index (Z)
  • 5-CH DO 24Volt-200mA NPN to enable motor servodrive
  • 1-CH DO 24Volt-200mA NPN to enable inverter servodrive
  • 2-CH DO 24Volt-200mA NPN for general output
  • 1-CH 12 bit analog-output +- 10Volt
  • 2-CH 12 bit analog-input 0+10Volt, input impedance 1Mohm, high precision for measuring device
  • 1 source output 5V for precision Switch
  • 1 receive low current, high speed signal from precision Switch

 

EpoCAT FR1000

Empresa

AB&T

AB&T S.r.l.

Más información